Replace an E-240G-B ONU
90
7368 ISAM ONT E-240G-B Product Guide
3FE-46261-AAAA-TCZZA Issue: 01
11 Insert the ONU and faceplate assembly into the MNTS-A shelf and tighten the 2 panel
screws.
12 Reconnect the user cables, the power cable, and the PON cable.
13 Repeat this procedure for any additional ONUs in the shelf that need to be replaced.
14 STOP. This procedure is complete.
Warning — Be careful to maintain a bend radius of no less than 1.5
inches (3.8 cm) when connecting the fiber optic cable. Too small of a
bend radius in the cable can result in damage to the optic fiber.
Caution — Be careful not to damage the PON connector. Consider
cleaning the connector before you insert it.
Release 06.01.01 | June 2019 | Edition 09
To Next Page
Loading...
