7368 ISAM ONT E-240W-A Product Guide Configure an E-240W-A indoor ONT
Issue: 01 3FE-46974-AAAA-TCZZA 101
2 Select a tunnel interface.
3 Enter a VLAN ID and priority level.
4 Click Save.
5 To delete a policy, click the Delete option for the applicable policy in the policy table.
A policy can only be deleted if it is not associated with any classifier rules.
6 Configure the US classifier.
At least one field must be selected to create a classifier. A maximum of four fields may be
selected to create a classifier; this includes the interface field.
7 Click Save.
8 To delete a classifier, click the Delete option for the applicable classifier in the classifier table.
A classifier can only be deleted if it is not associated with any classifier rules.
9 Configure the classifier rule.
10 Click Save.
11 To delete a classifier rule, click the Delete option for the applicable classifier rule in the
classifier rules table.
12 STOP. This procedure is complete.
Procedure 26 QoS configuration
1 Select Network > QoS Config from the top-level menu in the Home Gateway window.
Figure 42 shows the window for configuring QoS L3 (Layer 3 packet sizes).
Release 06.00.00h | January 2019 | Edition 08
To Next Page
Loading...
