RADIUS ATTRIBUTES REFERENCE GUIDE
RELEASE 14.0.R4
RADIUS Attributes Reference
Issue: 01 3HE 10793 AAAB TQZZA 01 107
30 Called-Station-Id If configured for inclusion in authentication and accounting policy
(configure aaa isa-radius-policy policy-name auth-include-
attributes/acct-include-attributes called-station-id), the called-
station-id received from EAP authentication request is transparently
forwarded in access-request. If it is contained in the accounting
messages received from the APs, it is transparently forwarded in the
accounting messages sent from the WLAN-GW. For open SSIDs, [30]
Called-Station-Id is not included in authentication or accounting.
Typically the string contains “AP MAC : SSID-name”.
31 Calling-Station-Id Calling-station-id contains the MAC address of the UE, if it is configured
for inclusion in isa-radius-policy (configure aaa isa-radius-policy
policy-name auth-include-attributes calling-station-id) for
authentication generated from the ISA (for a UE in migrant state), or in
authentication and accounting policy for messages generated from the
CPM. For CPM generated authentication or accounting, the inclusion of
calling-station-id MUST explicitly specify the format of the calling-
station-id as MAC: configure subscriber-mgmt authentication-
policy | radius-accounting-policy name include-radius-attribute
calling-station-id mac.
87 NAS-Port-Id A text string with format defined by the aggregation type:
GRE or L2TPv3: “tunnel-type rtr-virtual router id#lip-local ip
address#rip-remote ip address”
where
tunnel-type = GRE | L2TP,
rtr-virtual router id is the transport service
lip-local ip address is the local tunnel end-point
rip-remote ip address is the remote tunnel end-point
Example: NAS-Port-Id = “GRE rtr-11#lip-50.1.1.1#rip-201.1.1.2”
VLAN: “VLAN svc-svc-id[:vlan[.vlan]]”
where
svc-svc-id is the relative identifier of the internal
_tmnx_WlanGwL2ApService Epipe service connecting the WLAN-GW
group interface SAP to the MS-ISA.
[:vlan[.vlan]] is the optional dot1q or qinq encapsulation identifying the
AP
Example: NAS-Port-Id = “VLAN svc-1:10”
Table 31 WLAN Gateway (Description) (Continued)
Attribute ID Attribute Name Description
To Next Page
Loading...
