Nokia 7750 - 2.2.6 IP and IPv6 Filters

RADIUS ATTRIBUTES REFERENCE GUIDE
RELEASE 14.0.R4
RADIUS Attributes Reference
Issue: 01 3HE 10793 AAAB TQZZA 01 87
2.2.6 IP and IPv6 Filters
Table 16 Accounting: On-Line Charging (Applicability)
Attribute ID Attribute Name Access
Request
Access
Accept
CoA Request
26-6527-95 Alc-Credit-Control-
CategoryMap
00-10-1
26-6527-96 Alc-Credit-Control-
Quota
0+ 0+ 0+
Table 17 IP and IPv6 Filters (Description)
Attribute ID Attribute Name Description
92 NAS-Filter-Rule Subscriber host specific filter entry. The match criteria are automatically
extended with the subscriber host ip- or ipv6-address as source
(ingress) or destination (egress) ip. They represent a per host
customization of a generic filter policy: only traffic from/to the subscriber
host will match against these entries.
A range of entries must be reserved for subscriber host specific entries
in a filter policy: configure filter ip-filter/ipv6-filter filter-id sub-insert-
radius
Subscriber host specific filter entries are moved if the subscriber host
filter policy is changed (new SLA profile or ip filter policy override) and
if the new filter policy contains enough free reserved entries.
When the subscriber host session terminates or is disconnected, then
the corresponding subscriber host specific filter entries are also deleted.
The function of the attribute is identical to [26-6527-159] Alc-Ascend-
Data-Filter-Host-Spec but it has a different format. The format used to
specify host specific filter entries (NAS-Filter-Rule format or Alc-
Ascend-Data-Filter-Host-Spec format) cannot change during the
lifetime of the subscriber host.
Mixing formats in a single RADIUS message results in a failure.