RADIUS Attributes Reference
98
RADIUS ATTRIBUTES REFERENCE GUIDE
RELEASE 14.0.R4
3HE 10793 AAAB TQZZA 01 Issue: 01
2.2.7 Subscriber Host Creation
Field Length Value
Destination port qualifier 1 byte 0 = no compare
1 = less than
2 = equal to
3 = greater than
4 = not equal to (not supported)
Reserved 2 bytes ignored
Table 21 [26-529-242] Ascend-Data-Filter Attribute Format (Continued)
Field Length Value
Table 22 Subscriber Host Creation (Description)
Attribute ID Attribute Name Description
8 Framed-IP-Address The IPv4 address to be configured for the host via DHCPv4 (radius
proxy), IPCP (PPPoE) or data-triggered subscriber management.
Simultaneous returned attributes [88] Framed-Pool and [8] Framed-IP-
Address (RADIUS Access-Accept) are handled as host setup failures.
Attribute is also used in CoA and Disconnect Message (part of the ESM
or AA user identification-key). Attribute is omitted in accounting via
configure subscriber-mgmt radius-accounting-policy name
include-radius-attribute no framed-ip-addr.
87 NAS-Port-Id A text string which identifies the physical port of the NAS (SAP id) where
the host is created.
26-6527-14 Alc-Force-Renew An individual DHCPv4 session is renewed with a CoA with attribute [26-
6527-14] Alc-Force-Renew. The NAS initiates the ForceRenew
procedure with re-authentication (triggers dhcp Force Renew to client
and start re-authentication on dhcp Request received).
26-6527-15 Alc-Create-Host Used to create an IPv4 host via CoA. Additional mandatory attributes to
create such a host are [8] Framed-IP-Address, [87] NAS-Port-Id and
[26-6527-27] Alc-Client-Hardware-Addr
26-6527-27 Alc-Client-Hardware-
Addr
MAC address from a user that requests a service and included in CoA,
Authentication or Accounting (configure subscriber-mgmt
authentication-policy/radius-accounting-policy policy-name
include-radius-attribute mac-address)
To Next Page
Loading...
