RADIUS ATTRIBUTES REFERENCE GUIDE
RELEASE 14.0.R4
RADIUS Attributes Reference
Issue: 01 3HE 10793 AAAB TQZZA 01 271
Notes:
1. Only one of the three identification methods should be used in a Disconnect Request, otherwise
the system will reject it by sending a Disconnect-NAK with [101] Error-Cause value set to 404
(Invalid Request).
2. If there are multiple tunnels having the specified IDi, then all these tunnels will be terminated.
2.4.5 Dynamic Data Services Identification Attributes
This section details the attributes that can be used in a CoA and Disconnect
Message to identify Dynamic Data Services associated with a dynamic service data
trigger.
To identify Dynamic Data Services associated with an Enhanced Subscriber
Management (ESM) control channel, the CoA and Disconnect Messages must be
send to the control channel. See section "Subscriber Host Identification Attributes"
for attributes that can be used as key.
Table 90 lists the attributes that can be used in a CoA and Disconnect Message to
identify one or multiple Dynamic Data Services associated with a dynamic service
data trigger.
Table 89 Disconnect Message: IPSec Tunnel Identification Attributes
ID method
1
Attribute ID Attribute Name Notes Identifies
1 87 NAS-Port-Id NAS-Port-Id+
Alc-IPsec-Serv-Id +
a single IP Address
or IPv6 Prefix
attribute
Single IPSec Tunnel
26-6527-61 Alc-IPSec-Serv-Id
8
97
Framed-IP-Address
Framed-IPv6-Prefix
2 44 Acct-Session-Id — Single IPSec Tunnel
for a given public
service
3 1 User-Name — All IPSec Tunnels
with the User-Name
as the IDi
2
To Next Page
Loading...
