RADIUS Attributes Reference
110
RADIUS ATTRIBUTES REFERENCE GUIDE
RELEASE 14.0.R4
3HE 10793 AAAB TQZZA 01 Issue: 01
26-6527-189 Alc-Wlan-Dsm-
Egress-Policer
Specifies the name of a distributed subscriber management (DSM)
egress policer configured under configure subscriber-mgmt wlan-gw
distributed-sub-mgmt dsm-policer policer-name. This policer will be
applied to the DSM UE. This overrides the value configured under
configure service ies/vprn service-id subscriber-interface
subscriber-interface-name group-interface group-interface-name
wlan-gw vlan-tag-ranges range start starting-vlan end ending-vlan
distributed-sub-mgmt egress-policer policer-name.
26-6527-190 Alc-Wlan-Handover-
Ip-Address
IP address provided in RADIUS Access-Accept message to signal
handover from LTE or UMTS to WIFI. If this VSA is present, handover
indication is set in GTP session creation request to PGW/GGSN.
26-6527-206 Alc-Wlan-SSID-
VLAN
The VLAN is transparently taken from the UEs Ethernet layer and can
be reflected in both authentication and accounting. This is typically
added by the Access Point and uniquely identifies an SSID. This is
useful when the SSID is not available in the [30] Called-Station-Id (e.g.,
datatrigger scenarios). When this attribute is configured for inclusion but
no VLAN is present in the UE payload, the attribute will not be reflected
in RADIUS.
When this attribute is sent in an Access-Accept message for a radius-
proxy, the VLAN will be used to perform SSID validation. If there is
already an active UE and there is a mismatch between both VLANs, the
UE will be removed. If there is no UE present yet, the VLAN will be
stored and any subsequent data-plane packets (e.g. DHCP Discover)
will be dropped unless the stored VLAN is matched.
26-6527-216 Alc-Datatrig-Lease-
Time
Defines the initial lease-time used for data-triggered DHCP relay hosts.
If this attribute is not provided or equal to zero, the used lease-time will
be 7 days. This lease time will be overridden upon the first renew after
data-triggered host-creation.
26-6527-218 Alc-Wlan-Handover-
Ipv6-Address
Specifies the current IPv6 address of the UE in a 3GPP-to-WLAN
handover scenario. In GTPv2 this sets the HI bit and signals the IP in
the PDN Address Allocation IE. In GTPv1 this is not supported.
26-6527-233 Alc-Tunnel-QoS-
Override
Used to override WLAN gateway tunnel HQoS parameters (aggregate
rate and scheduler PIR/CIR), and enables per-tunnel customization.
This attribute will be included in a per-UE RADIUS message, and the
value will be applied to the tunnel with which the tunnel is currently
associated. To remove an override, an empty value should be signaled.
When removing an override, the tunnel QoS will revert to the configured
values. It is not possible to revert to a previously applied override. It is
also not possible to enable QoS via overrides. Tunnel QoS must be
enabled on the WLAN gateway for overrides to function.
Table 31 WLAN Gateway (Description) (Continued)
Attribute ID Attribute Name Description
To Next Page
Loading...
