RADIUS Attributes Reference
154
RADIUS ATTRIBUTES REFERENCE GUIDE
RELEASE 14.0.R4
3HE 10793 AAAB TQZZA 01 Issue: 01
2 User-Password The password of user requesting user-Authentication, Authorization,
Accounting and always encrypted in a fixed length
4 NAS-IP-Address The identifying IP Address of the NAS requesting the Authentication or
Accounting. Included when the RADIUS server is reachable via IPv4.
The address is determined by the routing instance through which the
RADIUS server can be reached:
“Management”— The active ipv4 address in the Boot Options File (bof
address ipv4-address)
“Base” — The ipv4 address of the system interface (configure router
interface system address address). The address can be overwritten
with the configured source-address (configure system security
source-address application radius ip-int-name | ip-address)
18 Reply-Message The attribute received in the Access-Challenge message for challenge-
response interactive authentication. The content of the Reply-Message
attribute is displayed to the user. The user is prompted for a response.
24 State The attribute received in the Access-Challenge message for challenge-
response interactive authentication and sent unmodified in the new
Access-Request
27 Session-Timeout The attribute received in the Access-Challenge message for challenge-
response interactive authentication. The maximum number of seconds
in which the user should provide the response. After this time, the
prompt is terminated.
28 Idle-Timeout The attribute received in the Access-Challenge message for challenge-
response interactive authentication. The number of seconds after which
the prompt is terminated when no user activity is detected.
31 Calling-Station-Id The IP address (coded in hex) from the user that requests
Authentication, Authorization, Accounting or “CONSOLE” when
requesting access from the serial port (Console).
44 Acct-Session-Id A unique, without meaning, generated number per authenticated user
and reported in all accounting messages and used to correlate users
CLI commands (accounting data) from the same user.
61 NAS-Port-Type Mandatory included as type Virtual (5) for telnet/ssh or Async (0) for
Console.
Table 54 CLI User Authentication and Authorization (Description) (Continued)
Attribute ID Attribute Name Description
To Next Page
Loading...
