RADIUS ATTRIBUTES REFERENCE GUIDE
RELEASE 14.0.R4
RADIUS Attributes Reference
Issue: 01 3HE 10793 AAAB TQZZA 01 17
88 Framed-Pool The name of one address pool or the name of a primary and secondary
address pool separated with a one character configurable delimiter
(configure router/service vprn service-id dhcp local-dhcp-server
server-name use-pool-from-client delimiter delimiter) that should be
used to assign an address for the user and maps to either:
1) dhcpv4 option [82] vendor-specific-option [9] sub-option [13] dhcpPool
if option is enabled on the node (configure service ies/vprn service-id
subscriber-interface ip-int-name group-interface ip-int-name dhcp
option vendor-specific-option pool-name) or
2) used directly as pool-name in the local configured dhcp server when
local-address-assignment is used and client-application is ppp-v4
(configure service ies/vprn service-id subscriber-interface ip-int-name
group-interface ip-int-name local-address-assignment). Alternative to
[26-2352-36] Ip-Address-Pool-Name and [26-4874-2] ERX-Address-
Pool-Name. Framed-Pool names longer than the allowed maximum are
treated as host setup failures. Simultaneous returned attributes [88]
Framed-Pool and [8] Framed-IP-Address are also handled as host setup
failures.
95 NAS-IPv6-
Address
The identifying IP Address of the NAS requesting the Authentication or
Accounting. Included when the RADIUS server is reachable via IPv6.
The address is determined by the routing instance through which the
RADIUS server can be reached:
“Management” — The active ipv6 address in the Boot Options File (bof
address ipv6-address).
“Base” or “VPRN” — The ipv6 address of the system interface (configure
router interface system ipv6 address ipv6-address).
The address can be overwritten with the configured ipv6-source-address
(configure aaa radius-server-policy policy-name servers ipv6-source-
address ipv6-address).
97 Framed-IPv6-
Prefix
ipv6-prefix/prefix-length to be configured via SLAAC (Router
Advertisement) to the WAN side of the user. Any non /64 prefix-length for
SLAAC host creation is treated as a session setup failure for this host.
This attribute is an alternative to [100] Framed-IPv6-Pool and [26-6527-
99] Alc-IPv6-Address, which assigns IPv6 addressing to the wan-side of
a host via DHCPv6 IA-NA. Attribute is also used in CoA and Disconnect
Message (part of the ESM or AA user identification-key). Attribute is
omitted in accounting via
configure subscriber-mgmt radius-
accounting-policy name include-radius-attribute no framed-ipv6-
prefix.
Table 2 Subscriber Host Identification (Description) (Continued)
Attribute ID Attribute Name Description
To Next Page
Loading...
