Nokia 7750 - Page 171

RADIUS ATTRIBUTES REFERENCE GUIDE
RELEASE 14.0.R4
RADIUS Attributes Reference
Issue: 01 3HE 10793 AAAB TQZZA 01 171
64 Tunnel-Type (L2TP LAC and LNS only) The tunneling protocol(s) to be used (in the
case of a tunnel initiator) or the tunneling protocol in use (in the case of
a tunnel terminator). This attribute is mandatory in LAC Access-Accept
and its value must be L2TP.
The attribute is included in Acct-Request messages if the tunnel-
server-attrs (LNS) or tunnel-client-attrs (LAC) option is configured in
the configure subscriber-mgmt radius-accounting-policy name
include-radius-attribute CLI context.
65 Tunnel-Medium-Type (L2TP LAC and LNS only) The transport medium to use when creating
a tunnel for protocols (such as L2TP) that can operate over multiple
transports. This attribute is mandatory in LAC Access-Accept and its
value must be IP or IPv4.
The attribute is included in Acct-Request messages if the tunnel-
server-attrs (LNS) or tunnel-client-attrs (LAC) option is configured in
the configure subscriber-mgmt radius-accounting-policy name
include-radius-attribute CLI context.
66 Tunnel-Client-
Endpoint
(L2TP LAC and LNS only) The dotted-decimal IP address of the initiator
end of the tunnel. Preconfigured values are used when attribute is
omitted (configure router/service vprn service-id l2tp local-
address). If omitted in Access Accept on LAC and no local-address
configured, then the address is taken from the interface with name
system.
The attribute is included in Acct-Request messages if the t tunnel-
server-attrs (LNS) or tunnel-client-attrs (LAC) option is configured in
the configure subscriber-mgmt radius-accounting-policy name
include-radius-attribute CLI context.
67 Tunnel-Server-
Endpoint
(L2TP LAC and LNS only) The dotted-decimal IP address of the server
end of the tunnel is also on the LAC the dest-ip for all L2TP packets for
that tunnel.
The attribute is included in Acct-Request messages if the tunnel-
server-attrs (LNS) or tunnel-client-attrs (LAC) option is configured in
the configure subscriber-mgmt radius-accounting-policy name
include-radius-attribute CLI context.
68 Acct-Tunnel-
Connection
(L2TP LAC and LNS only) The format of the attribute in Acct-Request
messages can be configured with configure subscriber-mgmt
radius-accounting-policy name acct-tunnel-connection-fmt ascii-
spec. By default, the Call Serial Number is inserted.
The attribute is included in Acct-Request messages if the tunnel-
server-attrs (LNS) or tunnel-client-attrs (LAC) option is configured in
the configure subscriber-mgmt radius-accounting-policy name
include-radius-attribute CLI context.
Table 62 Enhanced Subscriber Management Accounting (Description) (Continued)
Attribute ID Attribute Name Description