Nokia 7750 - Page 174

RADIUS Attributes Reference
174
RADIUS ATTRIBUTES REFERENCE GUIDE
RELEASE 14.0.R4
3HE 10793 AAAB TQZZA 01 Issue: 01
99 Framed-IPv6-Route The routing information (IPv6 managed route) to be configured on the
NAS for a v6 wan-host (IPoE or PPPoE) that operates as a router and/
or a DHCPv6 IA-PD host modeled as a managed route. Valid RADIUS
learned managed routes and DHCPv6 IA-PD hosts modeled as a
managed route can be included in RADIUS accounting messages with
following configuration: configure subscriber-mgmt radius-
accounting-policy name include-radius-attribute framed-ipv6-
route. Associated managed routes for an instantiated routed subscriber
host are included in RADIUS accounting messages independent of the
state of the managed route (Installed, Shadowed or HostInactive). In
case of a PPP session, when a Framed-IPv6-Route is available while
the corresponding routed subscriber host is not yet instantiated, the
managed route is in the state “notYetInstalled” and will not be included
in RADIUS accounting messages.
123 Delegated-IPv6-
Prefix
Attribute that carries the Prefix (ipv6-prefix/prefix-length) to be
delegated via DHCPv6 (IA-PD) for the LAN side of the user (IPoE,
PPPoE). Maps to DHCPv6 option IA-PD [25] sub-option IA-Prefix [26]
Prefix. An exact Delegated-prefix-Length [DPL] match with configure
service ies | vprn service-id subscriber-interface ip-int-name ipv6
delegated-prefix-length [48 to 64] is required with the received
attribute prefix-length unless a variable DPL is configured (configure
service ies | vprn service-id subscriber-interface ip-int-name ipv6
delegated-prefix-length variable).In the latter case we support
multiple hosts for the same group-interface having different prefix-
length [48 to 64] per host. Simultaneous returned attributes [123]
Delegated-IPv6-Prefix and [26-6527-131] Alc-Delegated-IPv6-Pool are
handled as host setup failures. Attribute is also used in CoA and
Disconnect Message (part of the ESM or AA user identification-key).
Attribute is omitted in accounting via configure subscriber-mgmt
radius-accounting-policy name include-radius-attribute no
delegated-ipv6-prefix.
26-3561-1 Agent-Circuit-Id Information describing the subscriber agent circuit identifier
corresponding to the logical access loop port of the Access Node/
DSLAM from which a subscriber's requests are initiated. Attribute is
included/excluded based on configure subscriber-mgmt
authentication-policy/radius-accounting-policy name include-
radius-attribute circuit-id.
26-3561-2 Agent-Remote-Id An operator-specific, statically configured string that uniquely identifies
the subscriber on the associated access loop of the Access Node/
DSLAM. Attribute is included/excluded based on configure
subscriber-mgmt authentication-policy/radius-accounting-policy
name include-radius-attribute remote-id.
Table 62 Enhanced Subscriber Management Accounting (Description) (Continued)
Attribute ID Attribute Name Description