RADIUS Attributes Reference
20
RADIUS ATTRIBUTES REFERENCE GUIDE
RELEASE 14.0.R4
3HE 10793 AAAB TQZZA 01 Issue: 01
26-2352-36 Ip-Address-Pool-
Name
The name of an assigned address pool that should be used to assign an
address for the user and maps to dhcpv4 option[82] vendor-specific-
option [9] sub-option [13] dhcpPool if option is enabled on the node
(configure service ies | vprn service-id subscriber-interface ip-int-
name group-interface ip-int-name dhcp option vendor-specific-option
pool-name). Alternative to [88] Pool-Name and [26-4874-2] ERX-
Address-Pool-Name. Framed-Pool names longer than the allowed
maximum are treated as host setup failures. Simultaneous returned
attributes Pool-Names [8] and Framed-IP-Address are also handled as
host setup failures.
26-2352-99 RB-Client-NBNS-
Pri
The IPv4 address of the primary NetBios Name Server (NBNS) for this
subscribers connection and maps to 'PPPoE IPCP option 130 Primary
DNS Server address or DHCPv4 option44 NETBIOS name server. Is an
alternative for 26-4874-6 ERX-Primary-Wins or 26-6527-29 Alc-Primary-
Nbns.
26-2352-100 RB-Client-NBNS-
Sec
The IPv4 address of the secondary NetBios Name Server (NBNS) for this
subscribers connection and maps to 'PPPoE IPCP option 132 Primary
DNS Server address or DHCPv4 option44 NETBIOS name server. Is an
alternative for 26-4874-7 ERX-Secondary-Wins or 26-6527-30 Alc-
Secondary-Nbns.
26-3561-1 Agent-Circuit-Id Information describing the subscriber agent circuit identifier
corresponding to the logical access loop port of the Access Node/DSLAM
from which a subscriber's requests are initiated. Attribute is included/
excluded based on configure subscriber-mgmt authentication-policy/
radius-accounting-policy name include-radius-attribute circuit-id.
For data-triggered subscriber host authentication:
• in Access-Request, the attribute contains the source IPv4/IPv6
address of the data trigger packet
• when included in Access-Accept, the attribute is used as
circuit-id to build the IPoE session key when configure
subscriber-mgmt ipoe-session-policy policy-name circuit-
id-from-auth is configured.
For data-triggered subscriber host authentication, this attribute in the
Access-Request message contains the source IPv4/IPv6 address of the
data-trigger. The Access-Accept message can include this attribute to
specify the circuit ID of the IPoE session if the configure subscriber-
management ipoe-session-policy name circuit-id-from-auth
command is configured.
Table 2 Subscriber Host Identification (Description) (Continued)
Attribute ID Attribute Name Description
To Next Page
Loading...
