RADIUS Attributes Reference
26
RADIUS ATTRIBUTES REFERENCE GUIDE
RELEASE 14.0.R4
3HE 10793 AAAB TQZZA 01 Issue: 01
26-6527-16 Alc-ANCP-Str Information describing the subscriber agent circuit identifier
corresponding to the logical access loop port of the Access Node/DSLAM
from which a subscriber's requests are initiated and used to associate the
ANCP Circuit-Id (info received via ANCP Port Up and Port Down) with the
PPPoE/IPoE Circuit-Id (info received via [26-6527-16] Alc-ANCP-Str and
[26-3561-1] Agent-Circuit-Id). A subscriber is ANCP associated when
both strings are equal and for associated subscribers the ingress/egress
ANCP QoS rules apply (configure subscriber-mgmt ancp ancp-policy
policy-name and configure subscriber-mgmt sub-profile ancp ancp-
policy policy-name.
26-6527-18 Alc-Default-
Router
Maps to dhcp offer/ack message option [3] default-router for a dhcpv4
radius proxy scenario and defines the default gateway for the user. This
attribute is silently ignored if the NAS is doing dhcpv4 relay. In the latter
case the default-router is part of the dhcpv4 server configuration.
26-6527-27 Alc-Client-
Hardware-Addr
MAC address from a user that requests a service and included in CoA,
Authentication or Accounting (configure subscriber-mgmt
authentication-policy/radius-accounting-policy name include-
radius-attribute mac-address).
26-6527-28 Alc-Int-Dest-Id-
Str
A string representing an aggregation point (example, Access Node) and
interpreted as the intermediate destination id. Subscribers connected to
the same aggregation point should get the same int-dest-id string
assigned. The int-dest-id is used in mc-ring access redundancy to identify
subscribers behind a ring node (configure redundancy multi-chassis
peer ip-address mc-ring ring/l3-ring name ring-node ring-node-name).
The int-dest-id can be used in QoS to shape the egress traffic of a group
of subscribers to an aggregate rate using vports (configure port port-id
ethernet access egress vport name host-match dest destination-
string) or secondary shapers on HS-MDAv2 (configure port port-id
ethernet egress exp-secondary-shaper secondary-shaper-name). For
egress policed subscriber traffic, the int-dest-id can be used to select the
egress queue-group for forwarding (configure port port-id ethernet
access egress queue-group name host-match dest destination-string).
Strings longer than the allowed maximum are treated as setup failures.
26-6527-29 Alc-Primary-Nbns
The IPv4 address of the primary NetBios Name Server (NBNS) for this
subscribers connection and maps to PPPoE IPCP option 130 Primary
DNS Server address or DHCPv4 option44 NETBIOS name server. Is an
alternative for 26-2352-99 RB-Client-NBNS-Pri or 26-4874-6 ERX-
Primary-Wins.
Table 2 Subscriber Host Identification (Description) (Continued)
Attribute ID Attribute Name Description
To Next Page
Loading...
