RADIUS Attributes Reference
36
RADIUS ATTRIBUTES REFERENCE GUIDE
RELEASE 14.0.R4
3HE 10793 AAAB TQZZA 01 Issue: 01
26-6527-217 Alc-UPnP-Sub-
Override-Policy
Specifies the UPnP policy to use for this l2aware subscriber. The policy
must be configured in configure service upnp upnp-policy policy-
name.
Overrides the configured policy in the sub-profile for the subscriber:
configure subscriber-mgmt sub-profile name upnp-policy policy-
name.
The value “_tmnx_no_override” removes any existing override and
installs the upnp-policy configured in the sub-profile instead.
The value “_tmnx_disabled” creates a special override that disables UPnP
for this subscriber.
Specifying a non-existing policy results in a host/session setup failure or
in a CoA Reject.
All hosts belonging to the subscriber are affected by a UPnP policy
override.
Changing the upnp-policy will clear all existing upnp-mappings.
26-6527-228 Alc-Trigger-Acct-
Interim
When included in a CoA message an accounting interim update is
generated for all accounting modes that have interim-updates enabled.
The Alc-Trigger-Acct-Interim attribute with free formatted string value is
echoed in the CoA triggered accounting interim update message. The [26-
6527-163] Alc-Acct-Triggered- Reason attribute in the interim update is
set to 18 (CoA-Triggered).
26-6527-232 Alc-Acct-Interim-
IvI
Tagged Attribute.
The interval in seconds at which Acct-Interim-Update messages should
be generated. Overrides the local configured update-interval value in the
RADIUS accounting policy. Only takes effect if interim-updates are
enabled for one of the accounting modes in the RADIUS Accounting
Policy.
With attribute value=0, the interim accounting is switched off.
The tag value (1,2 or 3) indicates which RADIUS Accounting Policy in the
Subscriber Profile is updated.
To change the update interval of the first accounting policy, attribute [85]
Acct-Interim-Interval takes precedence over [26-6527-232] Alc-Acct-
Interim-Ivl with tag 1 when both are included.
Table 2 Subscriber Host Identification (Description) (Continued)
Attribute ID Attribute Name Description
To Next Page
Loading...
