Nokia 7750 - Page 68

RADIUS Attributes Reference
68
RADIUS ATTRIBUTES REFERENCE GUIDE
RELEASE 14.0.R4
3HE 10793 AAAB TQZZA 01 Issue: 01
26-6527-100 Alc-Serv-Id The service ID on the LNS node where the PPP sessions are
established (configure service ies/vprn service-id
subscriber-interface name group-interface name).
Preconfigured values are used if attribute is omitted (configure
subscriber-mgmt local-user-db local-user-db-name ppp
host host-name interface ip-int-name service-id service-id or
configure router/service vprn service-id l2tp group ppp
default-group-interface ip-int-name service-id service-id).
Values above the Limits or unreferenced are treated as a setup
failure.
26-6527-101 Alc-Interface Refers to the group interface ip-int-name on LNS node only
where the PPP sessions are established (configure service
ies/vprn service-id subscriber-interface ip-int-name group-
interface ip-int-name lns). Preconfigured values are used if the
attribute is omitted (configure subscriber-mgmt local-user-
db local-user-db-name ppp host host-name interface ip-int-
name service-id service-id or configure router/service vprn
service-id l2tp group ppp default-group-interface ip-int-
name service-id service-id). Alc-interface names longer than
the maximum allowed value are treated as session setup
failures.
26-6527-104 Alc-Tunnel-Serv-Id The service-id from which the tunnel should be established,
enables the tunnel origin to be in a VPRN (VRF). The default
value = Base. Values above the Limits or unreferenced are
treated as a setup failure.
26-6527-120 Alc-Tunnel-Rx-Window-Size Initial receive window size being offered to the remote peer.
This attribute is copied in AVP 10 L2TP Receive Window Size.
The remote peer may send the specified number of control
messages before it must wait for an acknowledgment. The
value with tag 0 is used as default for the tunnels where the
value is not specified. A preconfigured value is used when
attribute is omitted (configure router/service vprn service-id
l2tp receive-window-size). Values outside the allowed Limits
are treated as a setup failure.
Table 8 Wholesale-Retail: L2TP Tunneled Access Mode (Description) (Continued)
Attribute ID Attribute Name Description