Running the WEPGen utility
171
4 Click OK.
5 Enter the IP address of the target access
point.
6 Click
Send.
The data will be transferred. Any errors
which occur should be reported at this time.
The TFTP dialog box will remain on the
screen so that you can send to several
access points in turn by modifying the IP
address.
7 When you’re finished, click
Close.
Using TFTP
If you have saved a WEP key database using
the name
nids.txt you can transfer it to the
access point using a TFTP client utility (see
Using TFTP on page 103).
Briefly:
1 Enter the IP address of the access point.
2 Specify
nids.txt as the target filename
(destination).
A032-Adv.book Page 171 Monday, November 13, 2000 10:47 AM
To Next Page
Loading...
Need help?
General
