EasyManua.ls Logo

Nokia Communicator 9210 - Command Button Area

Nokia Communicator 9210
71 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
12 (71)
Copyright © Nokia Mobile Phones 2000. All rights reserved.
The screen returns to the Full Screen Mode if
a command (Menu or Command Button based) is executed
the Menu is closed, or
time-out has expired
Note: Command Button Area is not cleared if a dialog or note is open on the Screen. The Full Screen Mode is resumed
only when exiting the dialog/note.
3.4 Command Button Area
The Command Button Area is separated from the Application Area by a 5-pixel frame. Note that graphical
components of the UI shall NOT exceed the frame and overlap the Command Button Area.
The Command Button Area consists of four commands. The basic functionality of the device should be managed by
the command buttons.
Command texts are operated by the command buttons on the right-hand side of the display.
The size of the Command Button Area varies from 80 x 200 pixels to 130 x 200 pixels, depending on the length of the
text strings. The width of the command button area is dynamic but view dependent; it is as wide as the longest
command text string that could appear on the application screen in question. The width does not change in any one
view. The width must be adjusted according to each language version.
The first word of a command text starts with a capital letter. Use of abbreviations is not recommended. Command
texts are aligned to the right. The right margin is always 4 pixels wide and the left margin is a minimum of 4 pixels
wide. The left margin is wider if the Command Button Area is at the minimum and the texts are very short.
It is recommended to use one-line commands if the text consists of one or two short words. If the words are long or if
there are more than two words, the command text wraps to the second line. The command text, which is defined to
have/use the Enter key as a shortcut, is underlined by a 1-pixel line.
The command text colour is black. The command text might be dimmed if it is temporarily unavailable. Other colours
should not be used in command texts.
Roughly estimated, text string widths in the Command Button Area can extend from 7 to 12 characters per line,
depending on the width of the area.

Table of Contents

Related product manuals