Installing the FastMile 5G Receiver
22
User Guide
© 2022 Nokia. Nokia Confidential Information
Use subject to agreed restrictions on disclosure and use.
3TG-02285-AAAA-TCZZA-02
Ensure that the mounting area of the glass is clean and dry by using a supplied wet
wipe to clean the glass where the mounting sleeve is to be affixed, and then drying
with a supplied dry wipe.
Peel off the protective stickers from the four adhesive strips on the back of the
mounting sleeve.
Warning: A correct cable routing ensures the safety of your installation.
Observe the following cabling installation safety practices when finishing off installation of
the FastMile 5G Receiver on the outside of a window. Following these practices helps to
prevent accidents from potential water leakage through the window frame:
• It is recommended to create a cable loop outdoors whenever possible for a FastMile
5G Receiver with a pre-attached flat cable that is being mounted on the outside of a
window. This might not always be possible with a FastMile 5G Receiver that has the
pre-mounted ultra-flat (“thin”) cable (30 cm), but it is highly recommended for devices
with the pre-attached flat cable (1.5/2.5/10 m lengths provided by Nokia).
• Always use the provided cable clamp to lock the FastMile 5G Receiver pre-attached
PoE cable indoors (on a window frame or on the wall)
• Whenever possible, it is recommended to install the PoE injector so that the POE/WAN
port used for connecting the PoE injector to the FastMile 5G Receiver faces
downwards
• Ensure that the window seal is properly placed and not damaged during the installation
process
To Next Page
Loading...
