Nokia N73 - Voice Commands

Tools
108
Copyright © 2006 Nokia. All rights reserved.
a roaming agreement with your home network, that is,
the operator whose SIM card is in your device.
Glossary: A roaming agreement is an agreement
between two or more network service providers to
enable the users of one service provider to use the
services of other service providers.
Cell info display—Select On to set the device to indicate
when it is used in a cellular network based on microcellular
network (MCN) technology and to activate cell info
reception.
Enhancement
In the standby mode, indicates a compatible headset
is connected, and that the headset is unavailable, or a
Bluetooth connection to a headset is lost. indicates a
compatible loopset is connected and that a
compatible Text phone is connected.
Select Headset, Loopset, Text phone, Bluetooth
handsfree, or Car kit and from the following:
Default profile—Set the profile that you want activated
each time you connect a certain compatible enhancement
to your device. See “Profiles—set tones”, p. 95.
Automatic answer—Set if you want the device to answer
an incoming call automatically after 5 seconds. If the
ringing type is set to Beep once or Silent, automatic
answer is disabled. Automatic answer is not available for
Text phone.
Lights—Set whether lights remain on, or are switched off
after the time-out. This setting is not available for all
enhancements.
If you are using a Text phone, you must activate it on your
device. Press , and select Tools > Settings >
Enhancement > Text phone > Use text phone > Yes.
Voice commands
You can use voice commands to control your device.
For more information about the enhanced voice
commands supported by your device, see “Voice dialing”,
p. 68.
To activate enhanced voice commands for starting
applications and profiles, you must open the Voice comm.
application and its Profiles folder. Press , and select
Tools > Voice cm. > Profiles; the device creates voice tags
for the applications and profiles. To use enhanced voice
commands, press and hold in the standby mode, and
say a voice command. The voice command is the name of
the application or profile displayed in the list.