Nokia N95 - Security and Certificate Management

is set to Beep once or Silent, automatic answer
is disabled.
● Lights — Set whether lights remain on or are
switched off after the time-out. This setting is not
available for all enhancements.
TV-out settings
To change the settings for a TV-out connection,
select TV-Out and from the following:
● Default profile — Set the profile that you want
activated each time you connect a Nokia Video
Connectivity Cable to your device.
● TV screen size — Select the aspect ratio of the
TV: Normal or Widescreen for widescreen TVs.
● TV system — Select the analogue video signal
system that is compatible with your TV.
● Flicker filter — To improve image quality on the
screen of your TV, select On. The flicker filter may
not diminish image flicker on all TV screens.
Security settings
Phone and SIM
Press , and select Tools > Settings >
General > Security > Phone and SIM card.
● PIN code request — When active, the code is
requested each time the device is switched on.
Deactivating the PIN code request may not be
allowed by some SIM cards.
● PIN code, PIN2 code, and Lock code — You can
change the lock code, PIN code, and PIN2 code.
These codes can only include the numbers from
0 to 9.
If you forget the PIN or the PIN2 code, contact
your service provider. If you forget the lock code,
contact a Nokia Care point or your service
provider.
See "Access codes", p. 16.
Avoid using access codes similar to the
emergency numbers to prevent accidental
dialling of the emergency number.
● Keypad autolock period — Select whether the
keypad is locked when your device has been idle
for a certain period of time.
● Phone autolock period — To avoid
unauthorised use, you can set a time-out after
which the device automatically locks. A locked
device cannot be used until the correct lock code
is entered. To turn off the autolock period, select
None.
Tip: To lock the device manually, press the
power key. A list of commands opens.
Select Lock phone.
● Lock keys if slide closed — Select whether the
keypad is locked when you close the 2-way slide.
Tip: To lock or unlock the keypad manually
when the slide is closed, press the left
selection key, then the right selection key.
143
Settings