RM-11
Troubleshooting - RF CC Technical Documentation
Page 14 ©2005 Nokia Corporation Confidential Issue 2 09/2005
RF AGC Status Components in Phoenix
Note: Always measure resistance with the mobile terminal powered off.
l RF AGC Status in RF
LNA Gain (High/Low)
Rx IF AGC PDM settings
BBAMP Gain setting
Tx IF AGC PDM settings
Tx RF AGC PDM settings
PA AGC PDM settings
Note:
Note:
This RF AGC Status component only
This RF AGC Status component only
works in Call Mode.
works in Call Mode.
To Next Page
Loading...
