Nokia RM-11 Series - Synthesizer Setup Using Phoenix

CC Technical Documentation Troubleshooting - RF
RM-11
Issue 2 09/2005 ©2005 Nokia Corporation Confidential Page 31
Synthesizer Setup Using Phoenix
1. Open the Phone Control dialog box and put mobile terminal into Local Mode.
• UHF: Use Rx/Tx mode in PCS and Cell band. This allows for checking power to
both Rx and Tx circuits. Typically, use channel 384 in Cell band and 600 in
PCS band.
• Rx VHF: Use Rx mode, one band is enough.
• Tx VHF: Use Rx/Tx mode in both PCS and Cell band
2. Use
RF Main Mode dialog box to set:
•Band
• Channel
• Rx/Tx mode.
Note: Be sure the “Main Mode set successfully” message appears.