RM-11
Troubleshooting - RF CC Technical Documentation
Page 46 ©2005 Nokia Corporation Confidential Issue 2 09/2005
6. Select Rho ON, and click Execute.
Note: Be sure the “RHO command successful” message appears.
7. Measure the Tx Pout at the RF connector using the 8960 Call Box.
• Cell band Tx Pout = +11dBm
• PCS band Tx Pout = +12dBm
If you do not see these powers, probe the Tx path to find out where the signal stops.
1. After Local Mode/Main Mode/and CDMA Control are activated, adjust the PDM
values on the
RF PDM dialog box.
Note: If you do not measure the correct Tx power at the RF connector, use
the RF probe to determine where the failure occurs.
Local Mode (either PCS channel 600 or Cell chan 384):
• PA Gain PDM = +220
• RF AGC PDM = -512
• IF AGC PDM = -105 (PCS), -135 (Cell)
MAX MAX
MAXMIN MIN
MINMAX MAX
MAXMIN MIN
MIN
To Next Page
Loading...
