76Copyright © 2005 Nokia. All rights reserved.
Position settings
To change settings related to positioning, select Menu→Positioning→Position
settings.
GPS receiver
Select GPS receiver→GPS automatic to activate the GPS receiver only when you
open Positioning from the menu, send information using NMEA interface, or
receive a position request that is answered. Select GPS always on to have the GPS
receiver active all the time. Using the GPS receiver may drain the battery faster.
Allow position info sending
The GPS receiver may receive requests for position information, or for network
information that the service provider can use to calculate the approximate
position of the radio (network service). Position information sending is only
possible in the network mode and when transmission barring is not activated.
Note that this feature and its accuracy are dependent on the network, satellite
systems (when GPS is used), and the organisation receiving the information. This
feature may not function in all areas or at all times.
To set how the radio responds to position requests, select Allow position info
sending, and one of the following:
• Yes—The radio attempts to send position information whenever position
requests are received from numbers authorised by your organisation.
• No—The radio does not send position information when position requests are
received.
To Next Page
Loading...
