3
Click Save ALG.
4
Configure the following parameters:
Table 8-30 DMZ parameters
Field Description
WAN connection list Select a WAN connection from the list.
Enable DMZ Click to enable DMZ on the selected WAN connection.
DMZ IP Address Select Custom Settings and enter the DMZ IP address or select the IP address of a
connected device from the list.
5
Click Save DMZ.
END OF STEPS
8.37 Configuring access control
This procedure describes how to configure the access control level (ACL).
Note: ACL takes precedence over the firewall policy.
The trusted network object will be shared for all WAN connections; it is not applied individually
to a WAN connection.
1
Click Security→Access Control from the left pane. The Access Control page displays.
Figure 8-35 Access Control page
Configure a XS-2426G-B indoor ONT
Security configuration
Configuring access control
Nokia ONT
Review Review
December 2021
Issue 1 125
© 2021 Nokia. Nokia Confidential Information
Use subject to agreed restrictions on disclosure and use.
3FE-49546-AAAA-TCZZA
To Next Page
Loading...
