3. Volume
This control allows you to increase or decrease the device's
volume based on your preference and environmental
conditions.
Volume setting consists of 6 levels and it is set to 3 by default.
When you turn off and on the device, it will start with the last
volume level you chose.
This setting is common to all modes; changes will
take effect in all modes.
Adjusting the Volume
1. Press the Power & Settings Button once. Select volume using
the right and left buttons. The current value will be displayed on
screen.
2. Change the volume level using the plus (+) and minus (-) buttons.
3. Press the Power & Settings Button once to go back to the main
screen.
Because the volume level affects power consumption, we
recommend you not to increase it more than necessary.
Park
Goldfield
Beach
Field
IMPORTANT! When you change the volume of the device with
this setting, the volume of the metal zones adjusted by the
Tone Volume setting will also change proportionally.
You can connect wired headphones to the device with the
headphones adapter cable sold separately. The volume for
the headphones is also adjusted through the volume setting
of the device.
When wired headphones are attached, headphones icon will
appear in the info section at the top of the screen.
PARK
FIELD
BEACH
GOLDFIELD
BEAST
8
8
8
8
-
Iron Filter
3
3
5
3
-
Stability
0
0
0
0
-
Bottle Cap
Rejection
0
0
0
0
-
Ground Suppressor
0
0
0
0
-
Deep Target
Identification
-
-
-
-
0
Iron
Rejection
Search Mode
Default Iron Filter, Stability, Bottle Cap Rejection, Ground Suppressor, Deep Target Identification and Iron Rejection Settings
Deep Target Identification
Stability
0 6
2.6 Deep Target Identification
This feature allows non-ferrous deep targets, which are
masked or detected as iron (ferrous), to be detected as
non-ferrous.
You can adjust the Deep Target Identification (dt) value between
0-6 and 0 is the default value.
This feature can be used in all modes except the Beast mode with
both multi-frequency and single frequencies.
When you increase the value of this setting, the stability of the
device may diminish.
Adjusting the Deep Target Identification
To access this feature, select the Recovery Speed setting and
press the pinpoint button. When you navigate with the right and
left keys, the letters "dt" will appear on the right side of the screen.
You can change the value of the dt setting between 1-6 by using
the plus (+) and minus (-) buttons. When it is at 0, this feature is
off.
2.7 Iron Rejection Feature in Beast Mode
Beast mode, like the Gold Field mode, produces signals
for both non-ferrous and ferrous targets by changing
the frequency of the sound according to the strength of
the received signal. In order to distinguish ferrous
targets, especially those closer to the surface,
depending on the signal strength received from the
ferrous target, the device emits a lower tone than that
of the non-ferrous targets with the frequency varying
according to the strength of the signal.
You can adjust the Iron Rejection (Ir) value between 0-5 and 0 is
the default value.
When the value is increased, the probability of emitting a ferrous
tone for deep non-ferrous targets increases.
Adjusting the Iron Rejection
To access this feature, select the Recovery Speed setting and
press the pinpoint button. The letters "Ir" will appear on the right
side of the screen. You can change the value of the ‘’Ir’’ setting
between 1-5 by using the plus (+) and minus (-) keys. When it is at
0, this feature is off.
19
To Next Page
Loading...
