Nomadic NC-S1 - Table of Contents; Introduction

NC-S
1
Install & Operations Guide Ver. 240411 2 Nomadic Cooling Co
TABLE OF CONTENTS
INSTALLATION
INTRODUCTION ..........................2
IMPORTANT SAFETY INSTRUCTIONS ......3
NC-S
1
TECHNICAL SPECIFICATIONS .......4
NC-S
1
DIMENSIONS .......................5
ITEMIZED PARTS LIST .....................6
ADDITIONAL TOOLS ......................7
INSTALLATION INSTRUCTIONS:
PART 1: EXTERIOR UNIT ................8
PART 2: INTERIOR UNIT ...............10
PART 3: MAKE THE CONNECTIONS .... 11
PART 4: FILLING REFRIGERANT .......14
DISCLAIMERS .............................14
OPERATION
REMOTE CONTROL OPERATION .........15
CONTROL PANEL OPERATION ...........16
NC-S
1
CONTROLLER FAULT CODES .......16
NC-S
1
ELECTRICAL SCHEMATIC ..........17
WARRANTY POLICY ......................18
RETURNS, CANCELLATIONS, and
MISSING PARTS .........................19
Due to ongoing improvements, Nomadic Cool-
ing reserves the right to modify appearance
and specifications without notice.
INTRODUCTION
The NC-S
1
Mini-Split Air Conditioner (“AC
unit”) is designed and intended for instalation
on the side of a semi-truck, overand rig, van or
RV during or after the vehicle is manufactured.
The NC-S
1
is an excellent choice for main-
taining a comfortable and cool environment
in your vehicle. Our NC-S
1
models offer sev-
eral advantages, including simplified instala-
tion, reduced noise levels, improved energy
efficiency, and the power to cool your vehi-
cle during the hot summer months. Nomad-
ic Cooling is based in Arizona, so we know a
little bit about extreme heat environments!
Always bench test AC unit
before installing.
Check to ensure all required parts
are included (refer to page 6).
16680 N 51st Ave Units 4 & 5
Glendale, AZ 85306
(480) 576-2489
www.NomadicCooling.com/Support
Keep a record of the following information:
Model
Serial No.
Date Purchased
Installed By
NC-S
1
Split System AC Unit |
48V
24V
12V
Coming Soon!