Norac UC4 Total Control - Page 31

29
* Verify the Sprayer Wiring *
Step 5
⇒
↓
↓↓
↓ Press
PressPress
Press
⇒
↓
↓↓
↓ Left
Left Left
Left Up
UpUp
Up
• Use the sprayer's manual controls to move the left boom up. Do not
continue if the wrong boom moves or the direction is incorrect.
Use the multifunction hand-control (joystick) on the sprayer to raise
the left boom. If nothing happens, or the wrong boom moves, or the
boom direction is wrong, turn off the control panel. Consult the
installation manual for your system to check the hydraulic plumbing
and electrical wiring of your system. Turn on the panel again to
resume system setup.
↓
↓↓
↓ Left
LeftLeft
Left↑
↑↑
↑ OK
OK OK
OK
• Control panel confirms the wiring is correct.
• Continue the process with the remaining booms, as shown below.
Lower Left
Boom
⇒
↓
↓↓
↓ Press
PressPress
Press
⇒
↓
↓↓
↓ Left Dn
Left DnLeft Dn
Left Dn
Raise Right
Boom
⇒
↓
↓↓
↓ Press
PressPress
Press
⇒
↓
↓↓
↓ Rght Up
Rght UpRght Up
Rght Up
Lower Right
Boom
⇒
↓
↓↓
↓ Press
PressPress
Press
⇒
↓
↓↓
↓ Rght Dn
Rght DnRght Dn
Rght Dn
* Raise Main
Boom
⇒
↓
↓↓
↓ Press
PressPress
Press
⇒
↓
↓↓
↓ Main Up
Main UpMain Up
Main Up
* Lower Main
Boom
⇒
↓
↓↓
↓ Press
PressPress
Press
⇒
↓
↓↓
↓ Main Dn
Main DnMain Dn
Main Dn
* These prompts are only shown for sprayer types that support automatic
main boom height control.
** Some sprayer types do not support a wiring test. If you do not see any of
the messages in this step, simply continue on as prompted by the panel.
If other messages appear during this step, see page 37 for more information