Norac UC4 Total Control - Page 32

30
* Automatic Sensor Detect *
Step 6
Level
Level Level
Level ↓
↓↓
↓
⇒
↓
↓↓
↓ booms at
booms atbooms at
booms at
⇒
↓
↓↓
↓ 35 inch
35 inch35 inch
35 inch
⇒
height
heightheight
height
⇒
↓
↓↓
↓ Proceed?
Proceed?Proceed?
Proceed?
• If you have main boom roll control, manually level the boom.
• Then use the leveling chains supplied with your kit to position all
other boom sections such that the nozzles are 35 inches from the
ground.
• Toggle YES to continue.
Hold
HoldHold
Hold
↓
↓↓
↓
⇒
↓
↓↓
↓ AUTO
AUTOAUTO
AUTO
⇒
↓
↓↓
↓ until
untiluntil
until
⇒
↓
↓↓
↓ "Done"
"Done""Done"
"Done"
• Hold the AUTO Switch to begin the sensor detect sequence.
During the procedure you must hold the AUTO switch. If AUTO is
released before the next step is displayed, simply pres and hold again
to continue the procedure.
• Panel indicates the detection stage as it progresses.
The panel will display various messages as it is working. The
messages are displayed for informational and troubleshooting
purposes only.
If other messages appear during this step, see page 37 for more information