Installation Instructions
Improper location, installation, adjustment, alteration,
or modifications can cause injury or property damage.
Refer to this manual for proper instructions. For assis-
tance or additional information consult a qualified in-
staller, service agency, or Norcold.
Requirements
Installation must be made in accordance with these
installation instructions for the Norcold factor
warrant
to be in effect.
This appliance is desi
n certified under the latest
edition of ANSI Z21.19 standards b
the American Gas
Association and is approved b
the Canadian Gas
Association.
Installation must conform with local codes or, in the
absence of local codes with the followin
Standards as
applicable.
In the United States:
a. National Fuel Gas Code, ANSI Z223.1.
b. Manufactured Home Construction and Safet
Standard, Title 24 CFR, Part 32-80.
c. Standard for Recreational Vehicles, ANSI
A119.2.
When an external electrical source is utilized, the
refri
erator, when installed, must be electricall
rounded in accordance with local codes or, in the
absence of local codes, the National Electrical Code,
ANSI/NFPA 70.
In Canada:
a. Current CGA B149.1 and 2 installation code for
Propane Appliances and E
uipment.
b. Current CSA Z240.4 Gas E
uipped Recrea-
tional Vehicles and Mobile Housin
or the cur-
rent CSA Z240.4.2 Installation Re
uirement for
Propane Appliances and E
uipment in Recrea-
tional Vehicles.
c. Current CSA Z240.6.2/C22.2 No. 148 Electrical
Re
uirement for Recreational Vehicles.
When installed, the refri
erator must be electricall
rounded in accordance with current Canadian Electri-
cal Code C22.2 Parts 1 and 2.
Refrigerator Enclosure Dimensions
The followin
dimensions will allow the installation
and removal of the refri
erator. Also, the dimensions
provide the necessar
clearances for air circulation
around the refri
erator coolin
s
stem.
Refri
erator Enclosure Cut-Out Dimensions
Hei
ht Width Depth
24 1/8" 25 5/8" 16 7/8"
The refri
erator must be placed on a solid and level
floor awa
from heat
eneratin
sources. The floor
must be stron
enou
h to support the combined wei
ht
of the refri
erator and food.
Notice: Never install the refrigerator directly on car-
peting. To protect carpeting, the refrigerator
must be placed on a metal or wood panel
extending at least the full width and depth of
the refrigerator.
Hazardous vapors! The burner or spark from the refrig-
erator’s ignitor can ignite vapors causing fire or explo-
sion resulting in property damage, serious personal
injury or loss of life. Never store gasoline, combustible
materials and other flammable vapors and liquids in the
vicinity of the refrigerator.
Direct Vent Requirements
Interior Ventilation
An inlet and exhaust vent is re
uired to insure ade-
uate air flow. The refri
erator is e
uipped with an inlet
vent located at the bottom front of the refri
erator. The
installer is re
uired to provide the exhaust vent which
must have a cross sectional area of 30 s
uare inches
minimum. The exhaust vent is to be installed above the
top surface of the refri
erator so as not to trap hot air
enerated b
the coolin
unit. The refri
erator is
e
uipped with a DC ventilation fan to assist the air flow
across the refri
erator’s coolin
s
stem while operatin
the refri
erator in the Gas mode.
Installing the Vent-Air Intake/Exhaust Assy.
Improper location and installation can cause injury or
property damage. This refrigerator and it’s vents are
design certified by the American Gas Association and
the Canadian Gas Association. Any deviation or sub-
stitution will void the agencies’ certifications and the
Norcold warranty. Refer to this manual for proper in-
structions. Install the refrigerator and vents as directed
by Norcold without modification.
WARNING
WARNING
WARNING
3
To Next Page
Loading...
