Norcold DE / EV 0061 - Install the Refrigerator; Fasten the refrigerator into the enclosure

Installation Manual 11
Install the Refrigerator
1. Fasten the refrigerator into the enclosure (See
Art02289):
- Push the refrigerator fully into the enclosure opening.
DE/EV0041 models have four mounting
screws and DC/DE/EV0061 models
have six mounting screws.
- Put the mounting screws [41] through the mounting
ange [156] on both sides of the refrigerator.
If the mounting screws are not
through the upper hole of each
pair of holes in the mounting
anges, the side trim pieces will
not t correctly.
- Make sure the mounting screws are through upper
hole [121] of each pair of holes in the mounting
anges.
2. Install the side trim pieces (See Art02290 and Art02291):
- Open the door(s).
- Push the top only of each side trim piece [127] onto the metal frame [261] of
the refrigerator.
- While holding the top only of each side trim piece onto the metal frame, push
each side trim piece up and under the top grill [262].
- Align the hinges, the strike plate cover, and the strike plate with the openings
in the side trim pieces and push the remainder of each side trim piece onto
the metal frame of the refrigerator.
- The side trim should engage the metal frame and the inner tabs [263]
with a “snap” sound.
Connect the Drain Tube
If you do not connect the drain tube to another tube, the result will be water at the rear of the refrigerator.
1. Attach the drain tube to another tube which allows the defrost water of the refrigerator to correctly drain to a sump or to an area
outside the vehicle.
Art02290
262
261
127
263
Art02291
261
127
263
261
127
263
41
156
121
Art02289
- Locate the half-moon shaped openings in the door (See Art00985).
- Apply some of the silicone sealant between the door gasket and the plastic door liner and also ll the screw hole opening.
- Push the door gasket back against the door to allow the gasket to seal against the silicone sealant.
- Smooth the silicone sealant in the screw hole opening so it is even with the door cap.
- Remove any excess silicone sealant from the door cap with a dry paper towel.
- Trim off any excess cured silicone sealant.
CAUTION
!
NOTICE
CAUTION
!