Installation Manual 9
3. Change the position of the strike plate and the strike plate cover for both doors (See Art02662):
- Remove the screws [41]
that attach the strike plates
(with hole) [65] and the
strike plate covers (without
hole) [63].
- Reverse the strike plates
and the strike plate covers
and put each one on the
other side of the refrigerator
cabinet.
- Attach the strike plates and
strike plate covers with the
screws.
4. Change the position of the
door hinges and handle of
both doors (See Art02287 and
Art00985):
- Remove and save the
screws [41] that attach the
door handle [70] to each
door.
- Remove the door handle
from each door.
- Pull the panel retainers [37]
off each door.
- Reverse the panel retainers
and push onto opposite side
of each door.
- Reverse the door handle
and put on the other side of
each door.
- Attach each door handle
with the screws.
- Remove and save the plastic cap [42] that is opposite the upper hinge of each door.
- Remove the screw [72] from each door hinge [73].
- Remove each upper door hinge.
- Reverse the hinge and put on the opposite side of each door as the lower door hinge.
- Remove each lower door hinge.
- Reverse the hinge and put on the opposite side of each door as the upper door hinge.
- Attach the hinges with the screws that were removed from the other side of each door.
73
72
65
63
41
41
Art 02662
To Next Page
Loading...
