16 17
Setup SMS command
you send
Response
SMS
Controller function you activate
90 SETUP
Setup reset (Owner deleted)
and controller restart
93 VERSION First time Owner number entry
Setup SMS command you send Controller function you activate
91xx* User1 number entry (to delete: 910)
92xx* User2 number entry (to delete: 920)
93xx* Owner number entry (to delete: 930)
*xx marks the place of mobile phone number
Setup reset
For setup reset send the SMS “90” to the controller. AirPatrol responds
with SETUP report:
“Owner: All; Users: All; Pump: All; Param: 5, 24, 180, 30”.
This means Owner is not specified; all users can send commands;
the pump model is not specified, call commands are set to default;
“LOW TEMPERATURE” message will be sent when room temperature
drops below 5 °C , “NO POWER” message blackout is in 24 hours
and the “SERVICE” alarm message interval is 180 days,
“HIGH
TEMPERATURE” message will be sent when room temperature rises
abowe 30 °C
User setup
To set User numbers start your command SMS with “91”, followed by
the mobile phone number of the User. For example: “91+495012345” or
“915012345” to enter User1 number where “5012345” is the cell phone
number of User1 and +49 is the country code. User numbers (Owner,
User1, User2) can be international (with the “+” symbol and country
code) or local. The length of the number must be between 3-16 symbols
(“+” counts as one symbol). Multiple commands can be combined into
one SMS. When a User has been set, AirPatrol responds with a SETUP
report message.
Multiple commands
If you want to set up several parameters with one SMS, separate
commands with one of the following:
space
comma “
,”
semicolon “;”
For example, the SMS „91+49550111111 92+49550222222 9513 9720”
sets the User1 and User2 numbers, specifies the heat pump model as
“Fujitsu”, and determines that NO POWER message is sent immediately
in case of a power failure.
When a command in the multi-setup is incorrect, the Owner will receive
an error message. All the correct commands that precede the error
command in the multi-setup command will be activated.
Multi-setup sender will always receive SETUP report SMS from AirPatrol
to confirm that all commands arrived to the controller. There can be
spaces before and after a command but not inside a command as this
will interfere with the code.
To Next Page
Loading...