11
11. Plug the Power Cord (55) into the power socket
a
t the rear of the elliptical exerciser (see HOW
TO PLUG IN THE POWER CORD on page 12).
IMPORTANT: If the elliptical exerciser has
been exposed to cold temperatures, allow it
to warm to room temperature before plug-
g
ing in the power cord. If you do not do this,
the console displays or other electronic
components may become damaged.
The ramp will calibrate automatically when
the elliptical exerciser is plugged in for the
first time.
11
55
12. Make sure that all parts of the elliptical exerciser are properly tightened. Note: Some hardware may be
left over after assembly is completed. To protect the floor or carpet from damage, place a mat under the
elliptical exerciser.
To Next Page
Loading...
