NordicTrack 360 - Page 12

12
14. Orient the Cable Cover (63) as shown and slide
it onto the Press Arm Cable (66).
I
nsert the Press Arm Cable (66) into the Cable
Coupler (64) as far as possible. Firmly tighten
f
our M6 x 10mm Set Screws (114) into the
Coupler to hold the Cable in place.
Slide the Cable Cover (63) over the Cable
Coupler (64).
14
66
63
6
4
114
114
15. See drawing 15a. Slide the Rear Shroud (15)
under the Top Cover (24).
Attach the Top Cover (24) and the Front and
Rear Shrouds (14, 15) to the Top Frame (12)
with three M4 x 16mm Self-tapping Screws
(99).
See drawing 15b. Attach the Rear Shroud (15)
to the Base (1) with an M4 x 16mm Self-tapping
Screw (99).
99
99
12
14
15
24
15a
15b
99
15
1
16. Attach the Backrest (18) to the Upright (3) with
two M6 x 100mm Screws (113) and two M6
Washers (107).
16
18
3
107
107
113
113