6. Measure your heart rate if desired.
Before using
the handgrip
pulse sensor,
remove the
sheets of
clear plastic
from the metal
contacts. In
addition,
make sure
that your hands are clean.
Contacts
To measure your heart rate, stand on the foot
rails and hold the metal contacts on the handrail--
avoid moving your hands. When your pulse is de-
tected, a heart-shaped indicator will flash in the
right side of the display each time your heart beats,
one or two dashes will appear, and then your heart
rate will be shown. For the most accurate heart
rate reading, continue to hold the contacts for
about 15 seconds.
.
When you are finished exercising, remove the
key from the console.
Step onto the foot rails, press the Stop button, and
adjust the incline of the treadmill to the lowest
setting. The incline must be at the lowest setting
when you fold the treadmill to the storage posi-
tion, or you may damage the treadmill. Next, re-
move the key from the console and put it in a secure
place.
When you are finished using the treadmill, switch
the reset/off circuit breaker to the "off" position and
unplug the power cord. IMPORTANT: If you do
not do this, the treadmiIFs electrical compo-
nents may wear prematurely.
16
To Next Page
Loading...
Need help?
General
