NordicTrack C80I NETL79815.0 - Page 11

11
8. Set the Console Base (64) face down on a soft
surface to avoid scratching the Console Base.
Remove and discard the two indicated screws
(E). Then, remove the Pulse Crossbar (93).
4
64
93
8
9. IMPORTANT: To avoid damaging the Pulse
Crossbar (93), do not use power tools and do
not overtighten the #10 x 3/4" Screws (9).
Orient the Pulse Crossbar (93) as shown. Start
one #10 x 3/4" Screw (9) with one #10 Star
Washer (3) into each end of the Pulse Crossbar
and each of the Handrails (84, 85). Then, start
another #10 x 3/4" Screw and #10 Star Washer
into each end of the Pulse Crossbar; start all
four Screws, and then tighten them.
Insert the Console Frame (87) into the Handrails
(84, 85). Attach the Console Frame with four
1/4" x 1" Screws (4); start all four Screws, and
then tighten them. Be careful not to pinch the
Upright Wire (81).
4
9
9
9
3
3
93
81
85
87
84
E
4