12
10. Firmly tighten the two 5/16" x 1" Bolts (28)
and the four 5/16" x 1" Flat Head Screws (18)
(only one side is shown).
With the help of a second person, hold the con-
sole assembly (F) near the Right Handrail (85)
and the Left Handrail (not shown).
Connect the ground wire from the console
assembly (F) to the Console Ground Wire (58).
See the inset drawing. Connect the Upright
Wire (81) to the console wire. The connectors
should slide together easily and snap into
place. If they do not, turn one connector and
try again. IF YOU DO NOT CONNECT THE
CONNECTORS PROPERLY, THE CONSOLE
MAY BECOME DAMAGED WHEN YOU TURN
ON THE POWER. Then, remove the wire tie (G)
from the Upright Wire.
10
28
81
18
G
F
81
85
58
11. Set the console assembly (F) on the Left and
Right Handrails (84, 85). Make sure that no
wires are pinched. Insert the excess Upright
Wire (not shown) into the Right Handrail and the
ground wires (not shown) into the console
assembly.
Attach the console assembly (F) to the Pulse
Crossbar (93) with six #8 x 3/4" Screws (2); start
all six Screws, and then tighten them.
Attach the two Console Clamps (92) to the con-
sole assembly (F) with four #8 x 1" Screws (25).
11
93
85
2
2
25
2
2
84
F
92
92
To Next Page
Loading...
