16
17. Orient the Rear Console Cover (80) as shown.
Attach the Rear Console Cover (80) to the
Upright (4) with two M4 x 16mm Screws (101).
Next, orient the Front Console Cover (79) as
shown.
Attach the Front Console Cover (79) to the
Rear Console Cover (80) with two M4 x 16mm
Screws (101).
79
4
80
101
17
19. Make sure that all parts are properly tightened before you use the elliptical. Extra parts may be included.
Place a mat beneath the elliptical to protect the floor.
18. Attach the Tablet Holder (111) to the back of
the Console (7) with four M4 x 16mm Machine
Screws (9); start all the Machine Screws, and
then tighten them.
7
111
9
101
101
18
To Next Page
Loading...
