14
15. Align the upper end of the Storage Latch (56)
with the bracket on the Frame (52). Insert a
5/16" x 2 1/4" Bolt (4) through the bracket. This
should push a spacer (I) out of the other end.
Discard the spacer.
Attach the Storage Latch (56) with the 5/16" x 2
1/4" Bolt (4) and a 5/16" Nut (9).
Lower the Frame (52) (see HOW TO LOWER
THE TREADMILL FOR USE on page 39).
56
15
52
4
9
I
14. Raise the Frame (52) to the position shown.
Have a second person hold the Frame until
step 15 is completed.
Orient the Storage Latch (56) so that the decal is
facing away from the treadmill as shown.
Attach the lower end of the Storage Latch (56) to
the bracket on the base of the Upright (84) with a
5/16" x 1 3/4" Bolt (3) and a 5/16" Nut (9).
Raise the Storage Latch (56) to a vertical posi-
tion. Then, remove and discard the tie (H).
84
56
3
52
Decal
9
H
14
To Next Page
Loading...
