13
11. With the help of a second person, hold the con-
sole assembly (H) near the Handrails (74).
See the inset drawing. Connect the Upright
Wire (83) to the console wire (J). The connec-
tors should slide together easily and snap
into place. If they do not, turn one connector
and try again. IF YOU DO NOT CONNECT THE
CONNECTORS PROPERLY, THE CONSOLE
MAY BECOME DAMAGED WHEN YOU TURN
ON THE POWER.
Then, remove any wire ties (K) from the Upright
Wire (83).
83
H
J
K
11
83
J
74
12. Attach the console assembly (H) to the Handrails
(74) with four 5/16" x 2" Screws (2) and four
5/16" Star Washers (8); start all four Screws,
and then tighten them. Be careful not to
pinch the wires (J).
See the inset drawing. Insert the wires (J) into
the top of the Right Upright (84).
Next, locate the Wire Tie (123) included with the
hardware. Insert the Wire Tie through the small
hole (L) in the side of the Right Upright (84).
Then, tighten the Wire Tie around the wires (J)
and cut off the end of the Wire Tie.
12
2
8
H
8
2
74
74
J
84
123
84
J
L
To Next Page
Loading...
