EasyManuals Logo

NordicTrack NTL17919-INT.0 User Manual

NordicTrack NTL17919-INT.0
40 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #30 background imageLoading...
Page #30 background image
30
SYMPTOM: The displays of the console do not
function properly
a. Remove the key from the console and UNPLUG
THE POWER CORD. Next, remove the ve #8 x
3/4" Screws (2), and carefully pivot off the Motor
Hood (65).
Next, locate the Reed Switch (104) and the Magnet
(103) on the left side of the Pulley (49). Turn the
Pulley until the Magnet is aligned with the Reed
Switch. Make sure that the gap between the
Magnet and the Reed Switch is about 1/8 in.
(3 mm). If necessary, loosen the #8 x 1/2" Truss
Head Screw (101), move the Reed Switch slightly,
and then retighten the Screw. Reattach the Motor
Hood (see above), and walk on the treadmill for a
few minutes to check for a correct speed reading.
SYMPTOM: The treadmill will not connect to the
wireless network
a. Make sure that the wireless settings on the console
are correct (see page 26).
b. Make sure that the settings for your wireless net-
work are correct.
c. If you still have questions, go to support.iFit.com.
SYMPTOM: The displays of the console do not
function properly
a. If the console does not boot up properly, or if the
console freezes and does not respond, reset the
console to the factory default settings.
IMPORTANT: Doing this will erase all the
custom settings you have made to the console.
Resetting the console requires two people. First,
press the power switch into the off position. Next,
locate the small reset opening (A) on the back
edge of the console. Using a bent paper clip (B),
press and hold the reset button inside the opening,
and have a second person press the power switch
into the on position. Continue holding the reset
button until the console turns on. When the reset
operation is complete, the console will turn off and
then turn back on. If it does not, use the power
switch to turn the treadmill off and then on again.
Once the console turns on, check for rmware
updates (see step 5 on page 25). Note: It may take
a few minutes for the console to be ready for use.
65
2
2
2
2
a
103
101
104
1/8 in.
49
Top
View
a
A
B

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the NordicTrack NTL17919-INT.0 and is the answer not in the manual?

NordicTrack NTL17919-INT.0 Specifications

General IconGeneral
BrandNordicTrack
ModelNTL17919-INT.0
CategoryTreadmill
LanguageEnglish

Related product manuals