NordicTrack NTL79011.0

Questions and Answers:

M
Melissa BurnsJul 31, 2025
How to fix NordicTrack NTL79011.0 that won't turn on?
- I
  Isabella MooreJul 31, 2025
  First, ensure the power cord is properly plugged into a surge suppressor, and the surge suppressor is connected to a grounded outlet. Use a single-outlet surge suppressor meeting the specified requirements. Next, check that the key is fully inserted into the console after plugging in the power cord. Finally, examine the power switch on the treadmill frame near the power cord. If it's protruding, the switch has tripped; wait five minutes, then press the switch back in to reset it.
J
James RandallAug 6, 2025
What to do if my NordicTrack Treadmill turns off during use?
- E
  Eddie JordanAug 6, 2025
  If your NordicTrack Treadmill turns off during use, check the power switch. If the switch has tripped, wait five minutes, and then press it back in. Also, ensure the power cord is securely plugged in. If it is, unplug it, wait five minutes, and then plug it back in.
L
Lisa HamptonAug 13, 2025
How to recalibrate incline on NordicTrack NTL79011.0 Treadmill?
- L
  Lorraine MendezAug 13, 2025
  To recalibrate the incline, hold down the Stop button and the Speed increase button simultaneously. Insert the key into the console, then release both buttons. Press the Stop button, and then press either the Incline increase or decrease button. The treadmill will automatically rise to the maximum incline and then return to the minimum level.
E
elizabethfletcherAug 17, 2025
How to turn off demo mode on NordicTrack NTL79011.0 Treadmill?
- H
  Heather GomezAug 18, 2025
  The console may be in display demo mode. To turn it off, hold down the Stop button for a few seconds. If the displays are still lit, see THE INFORMATION MODE on page 23 to turn off the demo mode.
A
Ashley BennettAug 25, 2025
What to do if NordicTrack NTL79011.0 walking belt is off-center or slips?
- N
  Nicholas ThomasAug 26, 2025
  If the walking belt is off-center, remove the key and unplug the power cord. If the belt has shifted left, use a hex key to turn the left idler roller screw clockwise 1/2 turn. If it has shifted right, turn the screw counterclockwise 1/2 turn. When the walking belt is correctly tightened, you should be able to lift each edge 2 to 3 inches off the platform. Keep the belt centered. Plug in the power cord, insert the key, and run the treadmill for a few minutes. Repeat until centered.