9
81
8
82
7
94
6
8. Identify the Right Handlebar (81) and orient it as
shown.
Tip: Avoid pinching the Right Pulse Wire
(8). Attach the Right Handlebar (81) to the right
side of the Console Bracket (82) with three
M8 x 13mm Screws (94); start all the Screws,
and then tighten them.
Then, route the Right Pulse Wire (8) in the Right
Handlebar (81) through the Console Bracket (82)
as shown.
Repeat this step to attach the Left
Handlebar (6).
Avoid pinching
the wires
8
94
9
9. While a second person holds the Console (5)
near the Console Bracket (82), plug the Main
Wire (41) and the Left and Right Pulse Wires (7,
8) into the receptacles on the Console.
The connectors on the Main Wire (41) and the
Pulse Wires (7, 8) should slide easily into the
receptacles and snap into place. If a connector
does not slide easily into a receptacle, turn the
connector and try again. If you do not connect
the connectors properly, the Console (5) may
become damaged when you use the exercise
bike.
Insert the excess wire into the Console
Bracket (82).
Tip: Avoid pinching the wires. Attach the
Console (5) to the Console Bracket (82) with four
M4 x 15mm Screws (63); start all the Screws,
and then tighten them.
41
5
7, 8
63
63
82
Avoid pinching
the wires
To Next Page
Loading...
