8
4. Identify the Left Upright (84). Have a second
person hold the Left Upright near the Base (29).
See the inset drawing. Tie the wire tie in the
Left Upright (84) securely around the end of the
Upright Wire (91). Then, insert the Upright Wire
into the lower end of the Left Upright as you pull
the other end of the wire tie through the Left
Upright.
4
91
84
84
Wire
Tie
91
Wire
Tie
29
5. Hold the Left Upright (84) against the Base (29).
Be careful not to pinch the wires. Partially
tighten three 3/8" x 4" Screws (3) with three
3/8" Star Washers (10) into the Left Upright and
Base; do not fully tighten the Screws yet.
84
5
10
3
29
Wires
3. Press a Base Cap (87) into each side of the
Base (29).
87
87
29
3
To Next Page
Loading...
Need help?
General
