8
4. Hold the Left Upright (89) against the Base (94).
Be careful not to pinch the Upright Wire (81).
Partially tighten two 3/8" x 1 1/4" Screws (8)
with two 3/8" Star Washers (13) and two 3/8" x
2 3/4" Screws (7) into the Left Upright until the
heads of the Screws touch the Left Upright. Do
not fully tighten the Screws yet.
Attach the Right Upright (not shown) in the
same way. Note: There are no wires on the right
side.
89
94
4
81
8
7
13
13
3. Identify the Left Upright (89), which is marked
"Left." Have a second person hold the Left
Upright near the Base (94).
See the inset drawing. Tie the wire tie in the
Left Upright (89) securely around the end of the
Upright Wire (81). Then, pull the other end of the
wire tie until the Upright Wire is routed through
the Left Upright.
81
3
81
89
Wire
Tie
Wire
Tie
89
94
81
To Next Page
Loading...
Need help?
General
