7
2. Make sure that the power cord is unplugged.
Attach the Right Wheel Cap (90) to the Base (94)
with two #8 x 3/4" Screws (2).
Attach the Left Wheel Cap (not shown) to the
left side of the Base (94) in the same way.
Cut the shipping tie holding the Upright Wire (79)
to the Base (94).
2
2
90
94
79
Tie
ASSEMBLY
• Assembly requires two persons.
• Place all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materials until you nish assembly.
• After shipping, there may be an oily substance
on the exterior of the treadmill. This is normal. If
there is an oily substance on the treadmill, wipe
it off with a soft cloth and a mild, non-abrasive
cleaner.
• Left parts are marked “L” or “Left” and right parts
are marked “R” or “Right.”
• To identify small parts, see page 6.
• Assembly requires the following tools:
the included hex key
one adjustable wrench
one Phillips screwdriver
scissors
To avoid damaging parts, do not use power tools
for assembly.
1. Go to www.iconsupport.eu and register your
product.
Registration provides the following benefits:
• activates your product manufacturer’s warranty
• saves you time if you ever need to contact
Customer Care
• allows us to notify you of upgrades and offers
Note: If you do not have Internet access, call
CUSTOMER CARE (see the front cover of this
manual) to register your product.
1
To Next Page
Loading...
