Optional Parts and Equipment 1 o-7
Equipment
Nordson Part No. Description
Auxiliary Equipment:
Timers
Automatic Standby Controller
Melter/Feeder for units using only
side-ported hoses
Melter/Feeder for units for units with
bottom-ported hoses
Melter/Feeder Conversion Kit
Automatic Hopper/Feeder
101 906
Nitrogen Blanket Kit
815 157
High-Capacity Tank Screen
Options Interface Board
Tank Calibration Kit
Hose/Gun Calibration Kit
Field Calibration Kit
(includes both of the above kits)
Hose Connector Cover Kit
Over-Voltage Protection Device Kit 109 703
See your Adhesives and Sealants
Equipment Catalog
105
827
110
663
110
772
112 133
111 346
276 893
276 633 For calibrating Series 2300 temp dials.
276 635 For calibrating Series 2300 temp dials.
276 632 For calibrating Series 2300 temp dials.
276 862
Protects hose electrical connectors at
manifold end of applicator from external
damage.
Depending on configuration of existing
Series 2300 applicator
Stores up to 150 Ibs (68 kg) of solid ad-
hesive
(Same as above)
Converts Melter/Feeders for Nordson
Model IV and V applicators for use with
Series 2300 applicators.
Stores adhesive in clean, dry state, auto-
matically feeds tank on demand.
Keeps nitrogen gas blanket over tank to
reduce oxidation or charring of easily
degradable materials.
For a higher melt rate, beyond that at-
tained with standard tank screen.
Allows for remote monitoring of power
on/off, over/under setpoint indication, low
material level indication, temp setback
on/off indication (if already installed);
also provides PMI capability and remote
control of temp setback operation (if al-
ready equipped).
For protection of the unit where the unit
was connected to a higher voltage input
than specified.
809 507
115 576
115 577
115 578
115579 .
115 580
115 581
810 004
Electrical Line Noise Filter Kit
Extension Cordsets:
2 ft (0.61 m) long
6 ft (0.1.83 m) long
12 ft (3.66 m) long
18 ft (5.49 m) long
24 ft (7.32 m) long
30 ft (9.14 m) long
Cordset Assembly, 8 ft (2.44 m) long
For applications where repeated oc-
curence of abnormally high voltage
spikes can cause loss of temperature
control or damage to the unit circuit
board.
All have plug connectors at each end.
For use in special applications where
plug connector required at one end, five
wires loose at other end.
Q No&on Corporation 1994
All Rights Reserved
P/N 106 701A
41-23OOSP - Issued 1194
To Next Page
Loading...
