3-1
Installation
© 2024 Nordson Corporation
1044131-06
Section 3
Installation
WARNING:
safety instructions in this document and all other related documentation.
NOTE: The information in this section is common for all versions of the 25B Pump. All
illustrations in this section show the 2:1 version of the pump, but installation procedures
are same for all versions.
Suitable for installation in Zone 1, Zone 2, or normal usage areas.
Mounting and Connections
See Figure 3-1, Figure 3-2, Figure 3-3, Figure 3-4, and Figure 3-5. Follow all safety
instructions.
WARNING: Install the pump according to all local codes and ordinances. Failure to do
so is dangerous and could result in loss of agency approvals and voiding of Nordson
warranties.
WARNING:
pressure less than the pump’s, install a pressure relief valve in the hydraulic system
set to open at that component’s maximum working pressure. This will protect against
equipment rupture and personal injury.
Mounting
Optional mounting kits are available as follows:
All versions: Wall mount kits
16:1 and 27:1 pumps Bucket (5 gal) and Drum 55 (gal) mount kits
Bucket and Drum mount kit installation are not covered in this manual.
See Figure 3-1.
1. Install the wall mount bracket (6) on a wall, stand, or wheeled dolly. Make sure there
will be enough clearance under the pump for a siphon hose, pressure feed system
plumbing, or circulation kit.
2.
in the top of the bracket. Thread the long hex nuts (7) included in the kit onto the front
3.
the mounting bracket.
To Next Page
Loading...
