Nordson iControl - Gateway Circuit Board Jumper Settings

iControlr PROFIBUSr, PROFINETr, DeviceNett, and EtherNet/IPt Generation 4 Slot 9 Gateway
7
Part 1605930−02
E 2020 Nordson Corporation
Gateway Circuit Board Jumper Settings
Verify that all jumpers and switch settings on the Slot 9 Gateway are
positioned as shown in Figure 3.
JP1
123
Note: No Jumper on JP1
OPEN
12
OPEN
1234
Default Positions for
DIP Switch SW1:
All “Open”
Default Positions for
DIP Switch SW2:
All “Open”
Reference Drawing 10013409_01
See SW2 Configurations
in Table 14 on Page 27.
SW2
Figure 3 Gateway Circuit Board Jumper Settings